DIY Modge Podge Glitter Hip Flask

Supplies you will need;

• Dishwasher safe Mod Podge Gloss 
• Stainless Steel Hipflask
• Glitter
• Clear tape
• Sponge (or something to apply glue)

Step 1 - Prepare the surface

Clean the flask in hot soapy water to make sure there isn't any dust or dirt on the surface.

Step 2 - Create design template 

Use the tape to create a design on the flask. This doesn't have to be perfect by any means, it's just an easy way to separate the different colour glitters.

Step 3 - Apply the glue

Using the sponge (or beauty blender/brush/hands/whatever you want), apply the Modge Podge in between the sections marked with tape. Try and apply and thin even coat so that it dries evenly.

Step 4 - GLITTER TIME!

I poured a small bit of glitter directly onto the glue and then used my fingers to even it out, just like finger painting with glitter ~ glitter painting even ~

I removed the tape and set it aside to dry for a few hours. I then repeated steps 3 & 4 until it was completely covered. To blend out the edges between the colours I took a small amount of glue and glitter on the sponge dabbed it on.

Step 5 - Finishing touches

I left it overnight to dry, just to be safe. I tapped it gently to remove any excess glitter and then sealed it to prevent any more glitter from falling off. The Modge Podge works as a gloss and a sealer, I applied two coats of this leaving about an hour in between each coat for drying time.

*Even though it does claim to be dishwasher safe I would not recommend putting this though the dishwasher. If you need to clean it, this is best done by hand washing it in warm water and not leaving it soaking in water for long periods of time as the glue may peel off!!

Until next time,

Sarah